The coolant level in the heat exchanger should be at the bottom of the filler neck. The throttle only button can be depressed only when the remote control handle is in the neutral position. Browse the Chevy repair manuals we currently have in stock below. If this information is not available, observe the following precautions when handling a battery. Clean or repair as necessary. You can download it free from Share this Product.
Allow the system to drain for a minimum of five minutes. We carry all the books published by Chilton and Haynes. Turn off the engine and remove the ignition key before adjusting tension or inspecting belts. Close fuel supply valve, if equipped. Remueve cualquier remanente de las juntas y limpia el interior del bloque utilizando un buen solvente. Una de las razones de esto es porque son fáciles de reparar.
If equipped with an alternative water pickup and not equipped with a seacock, disconnect the water hose from the alternative water pickup and plug both ends, excluding the Bravo sterndrive. Driveshaft splines and U-joint Engine Coupler Spline Grease 92-802869A1 O-rings. If the boat is in the water, keep the seacock closed until restarting the engine to prevent water from flowing back into the cooling system. Quitar todas las partes internas del motor te dará acceso a los pistones y rodamientos, que al ser reemplazados o rectificados sera lo que hará que la reparación sea buena o muy buena. If the circuit breaker is functioning properly, the yellow lever will appear. Fill to full line with specified fluid.
If damage is present or suspected, the power package should be taken to an authorized Mercury MerCruiser dealer for a thorough inspection and necessary repair. Damage caused by freezing is not covered by Mercury MerCruiser Limited Warranty. Both conditions may indicate a water leak somewhere in the sterndrive unit. If a submerged object is struck while the boat is moving forward, the hydraulic system will cushion the kickup of the sterndrive unit as it clears the object, reducing damage to the unit. Visually verify that water is draining. Remove the drain plug from the oil drain hose.
The Chilton and Haynes manuals have wiring diagrams and many have vacuum diagrams, which is indicated in the yellow triangle on the bottom right front cover of the Chilton books. Allow the system to drain for a minimum of five minutes. We do not know what percentage your boat's fuel system will withstand. Disconnect the Cool Fuel Module harness from the engine wiring harness. Install drive sleeve and locking tab washer.
The repair or replacement of parts or the performance of service under this warranty does not extend the life of this warranty beyond its original expiration date. Contact your authorized Mercury MerCruiser dealer. A circuit breaker provides protection for the engine wiring harness and the instrumentation power lead. Place the oil drain hose in a suitable container. Install the cap onto the heat exchanger. Give us a call or connect with us online to place your order for a Chevrolet repair manual today! The SmartStart feature incorporates push button starting. If leaks exist, stop the engine immediately.
Visually verify that water is draining. If water does not drain, remove the blue drain plug from the distribution housing and drain manually. Seawater pickups or sea strainer obstructed. Verify that water is draining from each opening. Thank you for purchasing one of our Mercury MerCruiser products.
Remove the air pump from the air manifold and return it to the mounting bracket. Changing Contact your authorized Mercury MerCruiser dealer. Description Where Used Part No. If the coolant level is low, contact your authorized Mercury MerCruiser dealer. Mercury MerCruiser recommends leaving the drain system open while transporting the boat or while performing other maintenance.